Ads by Google
Product Introduction
Preface
Wind Charge Controller is battery charger that can charge batteries by the power from the wind turbine. The charge controller is intelligent for charging batteries, it has 3 stages of charging batteries, first is current limited to charge batteries.
And is voltage limited to charge batteries, and 3rd is compensating to charge batteries. This will prolong the life of batteries.
Layout
Application
Wind Turbine Charge Controller can be used in wind power system, it has 3 phases AC input terminals, can connect to the 3 phases wire from the wind turbine directly. It can obtain the power from the wind turbine to charge the batteries to reserve the wind energy. The maximum volume of charging current is 15A, so it can charge batteries from 45AH to 300AH, and the rated power of wind turbine should be above 250W and less than 500W.
Specification
This model controller is 12V/24V/36V Battery Auto-Sensing.
Battery Voltage | 12V | 24V | 36V |
Rated Charge Current | 15A | 7.5A | 5A |
Maximum Charge Voltage | 14.4V | 28.8V | 43.2V |
Dump Load Resistor | 2 ohm/200W | 8 ohm/200W | 18 ohm/200W |
High Wind Protection | Yes (The controller will disconnect from wind turbine when wind Goes too high) When the wind goes low, the controller will re-connect to turbine again) | ||
Battery Reverse Protection | Yes | ||
Short Circuit Protection | Yes | ||
Overload Protection | Yes | ||
Operating Temperature | -5°C -- 40°C | ||
Control Method | PWM | ||
When the Battery is connected to the Charge controller, the controller will detect the voltage of the battery first, then it will decide how to charge the battery connected.
Mechanical Specifications:
N.W. | 1.5Kg |
G.W | 1.7Kg |
Dimension | 295mm*190mm*100mm |
200A Wind Charge Controller