1. Lightning Conductor 2. Un: 5V, Uc: 8V 3. Up: <50V, In: 5kA 4. Connection mode: Wiring terminal 5. Transmission rate: 2M

Lightning Conductor

Application range

LDY-C/P series SPD for control signal are applied to the front-end of control signal system, providing overvoltage protection arising from surge to control signal line or misoperation. (Option from standard IEC61643-21 and GB50343)

 

Main features

Modularization design, wiring terminal connection, convenient for installation and replacement;Adopt multilayer protection technology, strong protection ability, high reliability;Build-in earthing terminal, strong wiring ability, more reliable earthing;High current capacity and low output residual voltage.

 

Main technical data

Type	LDY-C/P5	LDY-C/P12	LDY-C/P24	LDY-C/P36
Nominal Operating voltage Un	5V	12V	24V	36V
Max. continuous operating Voltage Uc	8V	18V	36V	54V
Voltage protection level Up	< 50V	< 50V	< 80V	< 80V
Nominal discharge current In (8/20μs)	5 kA
Connection mode	Wiring terminal
Transmission rate Vs (bit/s)	2M
Insertion loss dB	≤0.5
Housing material	Enhanced flame retardant nylon (light gray, flame retardancy degree: V0)
Installation pattern	35mm standard DIN rail installment
Cross-section	≥ 2 mm2 stranded/flexible conductor

Installation instruction

1. The SPD is connected in series between the signal channel and the protected equipment.

2. Connect the input terminal to the signal channel, and the output terminal to the protected equipment.

3. Connect the earthing wire of SPD to the equalizing ring of the surge protection system.

4. The SPD is needless for special maintenance. When it is suspicious of SPD fault in system operation, please dismantle SPD module and then check. If the system recovers normality, SPD has broken down and needs replacement. During replacing SPD module, circuit will not be cut off and be in normal working.

 

Lightning Conductor