1 Used for reclamation of sewage 2 Japanese single row radial thrust ball bearings 3 High-strength alloy shaft, made of 42CrMo

SERVICE CONDITIONS1 Inlet pressure: 10-25MPa, outlet pressure: ≤40MPa2 Water temperature: <80°C 3 Supply voltage: 380V±5%, frequency: 50HZ, three-phase AC power with deviation not exceeding ±1% (please contact us if there is specific requirement)4 Solids content in water (in mass) less than 0.01%5 Wellhead pressure must be smaller than pump rated outlet pressure.

6 Use G68 bearing oil

MAIN FEATURES:

1) High inlet and outlet pressure; Good sealing effect; inlet pressure between 10-25MPa; re-pressurized to the pressure of the injection wells required; leakage 0.1m3/d (adjustable).

2) Running quietly; stable water injection; no obvious vibration; assured constant water injection.

3) Simple and safe operation; sub-axial design; easy to repair and maintain.

4) Energy efficient; significantly more efficient comparing to plunger pump.

STRUCTURE DECLARATION

1—motor; 2—coupling; 3—sealer(High pressure sealing device); 4—support; 5—pump body; 6—base plate

Water Injection Pump (High Pressure)