Marine submersible rule bilge Pump CE,OEM,Sample for testing 12V/24V,29mm outlet Vibration-free,Anti-airlock protect

Marine submersible rule bilge Pump  

CE,OEM factory,Sample for testing12V/24V,29mm outletVibration-free,Anti-airlock protectStainless stell shaft

DESIGN FEATURES 

1. The KGT submersible bilge pumps are tough enough for any bilge.

2. Impact resistant ABS housing. Protection against rust and corrosion

3. Permanent magnet motor uses composite brushes and permanently-lubricated bearings for long life.

4. Totally submersible and ignition protected.

5. To all existing safety standards.

6.  Water cooled motors for long life, with anti airlock design and moisture tight seals.

7. Snap-lock strainer base for easy installation and removal. Silent vibration free running.

8. No burn out if run dry

Specifications

Pump Spec:

1,Easy clean strainer; Low amp draw; Long pump lifetime2,Flow from 350GPH to 3700GPH (consult factory for other flow rate)3,Motor Configuration lead wires 1-pin connector(consult with factory)

4,1-pin connector without automatic switch which have to match with float switch

5,Outlet fitting: 19mm/3/4’’, 29mm/1-1/8’’, 40mm/1-1/2’’ (consult with factory)

6,Voltage: 12/24volts

7,Outlet diameter: 19mm to 40mm

8,A must for Bilge, boat, ship, marine, ditch, home, garden craft, yacht, and cruis

9,Technical date:

MATERIAL

Pump body:Thermoplastic

Shaft seal: Lip seal

Shaft:Stainless steel

Voltage: 12v dc/24v dc