Ads by Google
·Operation Notes1. Please read the instruction carefully before operating;2. Ensure whether the product consis{ with the machine;3. Forbid lubricaling the locking assembly fabric with oil containing molybdenum or silicon, which can lessen the locking force;4. The bolts used in our produel is level 12.9.Do not replace them with other;5. The producls have no orientation property, which can be added in the hub with your design.6. Do not hammer strongly when assembling;7. The recommended tolerance between axis and hub is H8/h8;·Installation Guidel. Clean linking facets of the locking assembly carefully, and daub lubricating oil evenly;2 Push the linked object into axis to the prescriptive position, assemble axis and hub smoothly. Make sure to tighten them without any leanness3. Please use a spanner In screw down the locking assembly according to following sequence: screw down with I/3Ma value, 1/2Ma value Ma and check all the bolths:4. After running wilh the load for five minutes, Screw down the bohs and check all again.·Disassemble Guide1. Ensure there is no any load before loosening Ihe bolt slowly2.if the bolt still can not be taken down after loosened, insert an bolt in whorl hole of the down cover board dand then clrumrotate the bolt to withst and up cover board until it is loosened;·Defend NotesI .After assembled, please daub lubricating oil on the top of the locking assembly and the end of Ibc bolt. Daub lubricating oil on the locking assembly regular to protect from rustiness, especially work under a worse2.When the locking assembly works in etching condition, special defence measures should be adopted to avoid rustiness;·Safety Notes and Reusing1. Please setting safety equipment when the products are used in elevators or manned meehallism to ensure safety;2. Prohibit to lossen the holt wilh load:3. Ensure that every part is clean, wilhonl any rustiness or dalnnification before reusing.
Locking assembly