UIM 24208 stepper motor controller Embedded DSP microprocessor, CAN2.0 network, and RS232 interface Networking, programmable

UIM 24208 stepper motor controller

Miniature Integral Design

Miniature size 42.3mm*42.3mm*13.5mm

Fit onto motors seamlessly

Die-cast aluminum enclosure, improving heat transfer and durability

Embedded DSP Microprocessor

Embedded 16-bit high-performance digital signal micro processor

Simple structured, intuitive, rich instructions

Intelligent, fault-tolerating, user-friend interface

CAN2.0B Active Communication

2-wire interface

1 Mega bit/sec operation, long distance

High noise immunity due to differential bus implementation

Motor Drive Characteristics

Wide supply voltage range 12 ~ 40VDC

Output current 8A, real-time adjustable through instruction

Automatic current reduction, real-time set through instruction

Full to 16th micro step resolution

Dual full H-bridge with PWM constant current control

Note: UIM250 RS232 to CAN Converter is needed for control at most 112 motors synchronously or individually.

CANBus protocol UIM24204-MSP stepper motor controller