Ads by Google
Product name: security alarm display stand holder for mobile phone
Model:DZ-03
Packing list:
Alarm display holder x 1pc
Phone charge line x 1pc
USB cable x 1pc
First Installation:
1. Set up defence for the display holder with the remote.
2. Clean the table and the backside of exhibit.
3. Tear off 3M adhesive tape at the bottom, stick the holder on table.
4. Tear off 3M adhesive tape of the magnetic module, and stick it at the back of exhibit.
5. Connect the cellphone and holder with phone charging line.
6. Connect the power adapter.
7. Finished installation.
How to use the remote:
Set up defence:
1. Use a small thick to turn on the button in a small hole at the bottom of the holder. LED indicator turns red.
2. Aim at the LED indicator and press "OFF" of the remote, one short sound comes out and LED indicator flash one time and remain red.
3. Press "ON" of the remote, one short sound comes out again and LED indicator goes out.
4. Finished set up defence.
5. Holders are only controlled by the remote which matched before.
6. Re-set up defence or change remote, please repeat the steps above.
3M Adhesive Tape:
Before using the tape, please follow next steps to make better effects.
1. Clean the surface of the table and the back of exhibition.
2. Do one side until finished other side to prevent bubbles.
3. Worked temperature: 15-38 degrees centigrade, do not lower than 10 degrees centigrade.
4. Please use it in 24 hours after it sticks 3M adhesive.
5. 3M adhesive is a one-off tape, do not reuse it.
Usage:
1. Use the remote, aim at the LED indicator and press "ON", two short sounds come out and LED light turns blue and flash.
2. When alarm, LED indicator flashes quickly, use the remote, aim at LED light and press "OFF".
ATTN:
Please charge the holder when LED indicator turns red.
Alarm:
1. Circuit break resistance
2. Short circuit resistance
3. Other circuit-replacing resistance
4. Prying and cutting resistance
5. Sensors loosened
6. Cut the spring wire
7. Put out the connector
8. Put out power connector