Mesh Belt Continuous High Temperature Carburizing Furnace 1. to produce PAN based,asphalt based and viscose based carbon fibers  Introduction     The equipment is mainly used for the continuous high temperature carbonization of pre-oxidized fiber, non-melting fiber and pyrolysis fiber under the protective atmosphere. It is one of the necessary equipment to produce PAN based, asphalt based and viscose based carbon fibers.  Composing    The equipment is composed of material feed and clean chamber, heating chamber, drive system, cooling system, air distribution system, electrical control system, rolling system etc.     The equipment is controlled automatically, with an automatic rolling device and belt deviation calibration device.  The inlet gas comes into the furnace from the bottom and the heating elements is embedded in the furnace. It is one of the best technical solutions for the carbonization of pre-oxidized fiber. Main Specifications and Accessories 

Specification	WTH-1000/260-10	WTH-1500/260-10
Width of Mesh Belt(mm)	1000	1500
Effective Cross-sectional Area(W×H×L)	1200×260×10000	1700×260×10000
Heating Zone	10	10
Rated Heating Power (kw)	450kw	600kw
Hight Temperature (°C)	1250
Cross-sectional Temperature Uniformity (°C)	±5
Air Consumption (Nm3/h)	Nitrogen≤120	Nitrogen ≤200
Rated Voltage (V)	Three phase,380±10%
Speed Control	Frequency conversion stepless speed control
Mesh Belt Material	SUS314S
Muffle Material	Silicon carbon and silicon nitride(high temperature section)
Overall Dimension(mm)(W×H×L)	2600×2000×25000	3100×2000×25000

 

Mesh Belt Continuous High Temperature Carburizing Furnace