EPON 5U OLT Introduction
5U equipment can be mounted in 19'' rack.
ControlSwitch Module: It's the main module of CLE9000-5, Offers the in-band, out-of-band management, switch and aggreagtion function.
XGM2A: It provides two XFP 10G ports used as the uplink port of OLT. At present, it only supports the optical module.
CEM4A: It offers four GE uplink ports, support the mixed insertion with ELM, at most can install 10 modules
ELM: Each ELM offers fours PON ports.
Fan and Filter: The sensor in the fan will monitor the fan status, and send the report if it has the failure.
Power supply: Support redundancy configuration
Physical Parameter | |
Dimension | 482.6 mm (width) x 332.4 mm (Length) x 221.5 mm (Height) |
Weight | 20kg(Equipped completely ) |
Power Supply | 2+1(1 is optional) AC power supply slots, input voltage 110/220V or 2+1(1 is optional)DC power supply slots, input voltage -48V (-40V~-72V DC) |
Power Consumption | Maximum 360W |
Redundancy Backup | Master control redundancy backup besides power supply |
Uplink Port | 4-40 GE ports(Four GE ports on each board, can be equipped 10 boards), support SFP transceiver, can use electric module or optical module |
OLT Port | at most forty PON ports, support SFP transceiver, can usevarious distance optical module, and connect with ONU through optical splitter |
MGNT Port | RJ45, 10/100Base-T out of band network management port |
CON Port | RJ45, Console port providing the diagnosis system |
EXT Port | RJ45 port providing connection alarm. |
Optical Port | |
Standard | IEEE802.3ah |
Fiber | Single mode fiber |
Connector | SC |
Optical loss | PX20, PX20+ Maximum distance is up to 60km |
Wavelength | The sent one:1490 nm; the received one:1310 nm |
ONU Authentication | MAC Authentication, SN Authentication |
Maximum splitting ratio | 1: 64 |
L2 Switch Function | |
Nonblocking switch | Line speed transfer |
L2 multicast | Support IGMPV2,V3-Snooping,IGMP-Proxy |
VLAN | 8K tagged (802.1Q) VLANs |
QinQ | Support QinQ, Flexible QinQ |
Link Converge | IEEE 802.3ad |
QoS | |
Type of service (CoS) | Support at most four CoS queues at each output port Support 802.1Q priority Supported queue system: Strict law, delay method, weighting method Support IPv4 TOS priority remapping Support IP Precedence, DSCP |
Speed control of output port | Token bucket function from 1 Mbps~1 Gbps Broadcast, multicast and DLF speed control based on port |
Bandwidth management: support DBA | |
Security | |
Encryption | AES-128, Triple Churning |
ACL | Strategy based on all kinds of protocol, source/target IP, source/target TCP/UDP port number and ToS combination Support permit, deny, DSCP remarking, rate limit or priority remarking |
Environment Parameter | |
Work temperature | -5ºC to +45º C |
Relative humidity | 5% to 90% no condensation |
Storage temperature | –40 to +75º C |
Storage humidity | 75% (Maximum) |
Management | |
Remote management | |
Support CLI |
5U Rack EPON OLT