650nm 5mW laser diode 1.low operating current 2.high precision package 3.high efficiency 4.high reliability 650nm 5mW High Power Laser Diode TO-18 5.6mm Package [JG22]

Speacialty

1:High power2.Wavelength:650nm3.Power Output:CW 5mW4.Working Temperature:-10 centigrade to 50 centigrade...

 

 

 

 

 

 

 

 

 

 

 

Safety Instructions:

1 Note: This laser diode may do harm to human eyes, when the laser tube is working, pay no direct attention to it.

2, The laser tube requires a suitable power supply, transient reverse current can`t exceed 25μA, reverse voltage can`t exceed 2V, otherwise it will damage the laser tube.

Plugged in before power up, initial output voltage should be 0V, the current regulation should be increased or decreased slowly to prevent impact damage to the laser tube.

Test the laser tube: insert or pull out the laser tube after the power off. Do not plug or unplug the laser tube when the power on, otherwise the laser tube will be damaged, invalid.

3, The laser tube should be kept or working in a dry environment to prevent condensation, condensation may damage the laser tube.

4, At high temperatures, it will increase the threshold current, lower the efficiency and accelerate the aging of the laser tube.

5,When the output power higher than the specified parameters, it will accelerate the aging of the laser tube.

6, The laser tube need to be used in fully heat or cooling conditions

7, Laser diodes are ESD sensitive device, anti-static measures should be prepared. Before pick up the case, make sure you get a good grounding condition, otherwise the laser tube will be easily to breakdown by the static electricity, resulting in the laser tube failure. Wear anti-static wrist strap when working with the laser.

650nm 5mW High Power Laser Diode TO-18 5.6mm Package [JG22]