Ads by Google
quick detail
|
Specification
How to use it:
| ONE STEP | After determining the proper location, take off the water tank from unit by lifting. |
| TWO STEP | Unscrew the valve-cap and set aside. |
| THREE STEP | Enter tap water below 40°C. |
| FOUR STEP | screw down the valve-cap to seal water tank. |
| FIVE STEP | Replace the water tank onto mainframe Base. |
| SIX STEP | Plug the unit into an electrical socket. |
| SEVEN STEP | ON/OFF and Mist Control Knob: Turns the humidifier on and off, and increase or lowers the amount of mist produced. |
| ENGHT STEP | When there is no water, machine will stop spray mist and the indicator light will show red. If you want to go on using it, put in more water. |
If your humidifier does not work, you can consult the following meansures:
| Faults | Cause | |
| Power light does not show | Not connected with electricity | Connected wire with socket |
| Power light does not show still | There is no electricity from socket | Plug in socket again |
| The machine is working, but no or little mist comes out. | 1. There is no water in tank.2. The machine is not placed level.3. There is hindrance in tank of water storage receptacle.4. There is deposits on energy exchange engine.5. Mineral-contained water has been used.6. Energy exchange engine has gone wrong. | 1. Fill in enough water. 2. Place it level.3. Clear with clean soft brush, then clean with water.4. Clean surface to energy exchange engine with cleaning solution.5. Use distilled water or clear tap water.6. Sent for repair. |